3/29/2024 0 Comments Enroute 4 key usb![]() ![]() Stereo Record + Multitrack Playback, not supported simultaneously.Stereo Playback + Multitrack Record, not supported simultaneously.Stereo Playback + Multitrack Playback, not supported simultaneously.Stereo Playback + Stereo Record, not supported simultaneously.The most recent entries can be found at the bottom of the list.īelow is a list of non-supported routing combinations. Once the USB is formatted for SQ-Drive, we recommend using the formatted drive for SQ recording only, and not used with other applications.Ī list of user tested USB drives can be found here. We recommend formatting the drive before each use, this clears the drive, sets up the folder structure and formats into FAT32. This will allow a maximum recording time per track of roughly 4 hours, and would need 64GB drive capacity for maximum recording time of 16 channels at 96kHz. The maximum USB drive size (FAT32 file system limit) is 2TB. The smallest USB drive size that should be used with SQ-Drive is 2GB. This is not obvious when looking at drives and you will need to consult the manufacturer’s data Only drives that communicate over USB Attached SCSI are supported. SCSI drives - hard drives using the SCSI command protocol ATAPI are not supported.HDD drives - magnetic drives are generally suitable for recording but can suffer from physical disturbances such as vibration due to low frequency exposure, which can throw the head off-track and cause a delay while the actuator repositions it, eventually impacting on the input/output performance.SSD drives - generally suitable for recording but can be prone to performance degradation over time, also some forms of wear levelling and 'garbage collection' algorithms can cause write speeds to become reduced during recording.USB flash 'key', 'stick', or 'thumb drive' - most keys on the market are not fast enough for multitrack recording.Please refer to the following guidelines for sourcing a suitable USB device. ![]() Not all USB devices will guarantee flawless performance. SQ-Drive – Record and Playback Stereo (2-Track) and Multitrack (16 or 32 channel*) using a USB drive. The sample rate can be switched to 48kHz in the Setup > Audio > USB page (V1.5+). The default recording format is WAV 96kHz 24bit Interleaved. USB 1&2 are assigned to stereo input 47/48 and labelled USB by default. The SQ can receive a signal from the USB bus and assign it to an input channel or mix external input. The direct output settings can be changed in Routing > Direct Out Settings > Global Direct Out Settings to:Ī per channel direct output trim is also available, along with other global setting which determine whether the direct out follows fader and mute setting for the channel and assigned DCA’s and mute groups.īy default, Tie Lines are used for input channel sends to USB and SQ-Drive is selected as the USB audio source, this can be changed to USB B in the Setup > Audio > USB page. For input channels, Tie Lines can be used to send an unprocessed, post preamp signal that isn't affected by any fader or mute controls, or the direct output. The SQ can use any output or Tie Line to route audio to the USB bus.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |